I just upgraded my system from Wincon to QUARC and I have a Quanser Q4/Q8 Hardware-in-the-loop board. Where can I obtain the drivers for my Q8 board, as well as instructions for their installation/setup?
Last Updated:
All drivers for the WinCon supported Quanser DAQ devices, Q8 and Q4 are installed automatically when QUARC is installed. To test your DAQ with QUARC run the “QUARC Analog Loopback Demo“. Type qc_show_demos in the MATLAB command window, scroll down and look for the “Using Hardware” demos group. When running this demo, make sure your DAQ has been selected in the HIL initialize block | Main tab | Board Type box.
