Can I achieve 10 kHz sample rate (0.0001 sec sampling interval) with the Quanser Q2-USB or Q8-USB Boards?
I just upgraded my system from Wincon to QUARC and I have a Quanser Q4/Q8 Hardware-in-the-loop board. Where can I obtain the drivers for my Q8 board, as well as instructions for their installation/setup?
My Quanser QPID/QPIDe board was working fine but the encoders suddenly stopped reading. What could be causing the problem?
Do the Quanser Q2-USB and Q8-USB data acquisition devices have a fuse or protective circuit on them, like the earlier Quanser Q4 and Q8 Hardware-in-the-loop boards?